HOW TO MEASURE RING SIZE
It is possible to obtain your ring size without the need to going to the jeweller. There are three methods that you can use to know your ring size. This will come in handy when you plan to surprise your partner with an engagement ring or if you want to buy a ring online. Below are the three methods, with a ring size chart at the end for your reference.
Method 1
What you need
Materials needed for measuring ring size
- Thin strip of paper
- Ruler
- Pen
How to measure
Steps in measuring ring size
- Wrap the strip of paper around the finger. Ensure that the paper is placed at the base of the finger and close to the knuckle.
- Mark the area where the paper strip meets.
- Use the ruler to measure the length.
Notes to bear in mind
Please take note that people with larger knuckles will have to consider the adequate size so that the ring can slide through the knuckle. Also, the size of the finger changes with changes in temperature, physical exercise, weight changes and medication.
If you are in doubt about the size, it is always advisable to go a size higher than lower.
Method 2
What you need
Materials needed for measuring ring size
How to measure
Steps in measuring ring size
- Cut a 6 inch string
- Wrap the string around the base of the ring finger and slightly below the knuckle
- Use the pen to mark the spot where the string overlaps with its end
- Lay the string on the ruler with
- The number closest to the pen mark is the ring size in inches
- You can use the ring chart below to convert the measurements into relevant ring sizing in different countries
Also: If there is no string or paper available, masking tape can be used, a wire or a twist-tie can also be used
Note: Masking tape, wire or twist-tie can also be used.
If you wish to get the ring size of the other person in without his/her knowledge, use one of the rings worn by the individual. Then, wear the ring until the point where it stops. Measure the area between the upper edge and lower edge of the ring. These measurements can help you get the ring size. Alternatively, if possible, bring the existing ring to a jeweller to get the exact measure.
The following chart can be used to determine the ring size. Please bear in mind that rings can come in half sizes too. The measurement of half rings will fall in the middle of whole ring sizes.